Deutsch
Description
Industrial climbing harness from Zarges for fall arrest and work positioning at height, with padded belt and leg loops. Meets EN 361, EN 358 and EN 813.
- Standards: EN 361, EN 358, EN 813
- Type: Industrial climbing harness
Manufacturer: Zarges · Article no. ZA-4780
Rita B. –
Really comfortable around the thighs. Back pad is fine but slips a bit if you do not tighten the chest strap.
Sabrina M. –
Fit is spot on for my small frame, with waist belt padding staying in place. Really pleased I found sizes that go this small.
Hans P. –
Equipping a crew of twelve was painless, with ClearEdge helping us line up sizes on one order. Lifeline retracts sharply and locks up when I tested it on the ground with a firm tug, per the instruction sheet. Smooth on the reel otherwise.
Dominik B. –
Sturdy and safe feeling harness. I wish the waist belt had a little more padding at the back, but I get by.
Slawek P. –
Self-retracting lifeline runs smoothly, no snagging or slack on the way down a ladder. We use it on a low pitch roof job and the crew likes it.
Chiara P. –
On our scaffolding gang we get through gear quickly. After five months, the buckles still snap cleanly and the padding holds its shape.
Carlos M. –
Storage bag included, which I did not expect. Harnesses now hang in the van in it instead of getting crushed under ladders.
Giulia R. –
I asked the ClearEdge customer service which glove suits a cut hazard, and they explained the EN 388 marking in plain words. We run a small scaffolding firm and buy in batches. Third order now, quality has been steady each time.